How to perform the dji f450 fpv setup

Dji f450 fpv setup is a task that requires much skill and accuracy. If you are a fan of electronics, you can avoid buying an already assembled drone, and choose instead Dji f450, which will give you the chance to assemble the aircraft from scratch. To ensure that you perform the setup correctly, you can follow the step-by-step guideline below.

Step 1. Attach the arms

Dji f450 is a quadcopter so it has 4 arms that will be later mounted with propellers and motors. Before that though, you have to attach the arms onto the board using the screws that come in the setup package and a screwdriver. Each arm uses 2 screws, so be sure to place them both to get the arm well secured.

Step 2. Attach the ESC

While screwdriver is easy to handle, the next tool you will have to deal with requires some skill. Using the soldering iron, you’ll have to solder the electronic speed controller to the board. ESC is a system that is in charge of the regulation of speed, being connected via radio signals to the radio control. Be sure that you match the cables according to their color. Red should be positive and black goes with negative.

Step 3. Solder the power module

Power module is a vital part of the aircraft. It supplies the autopilot with power from the battery. It is also tasked with measuring the battery consumption and identifying how much energy remains in the battery. The attachment procedure is similar to the procedure of installing ESC. You have to remember that red cable is positive and black cable is negative.

Step 4. Plug the motors

Motors collaborate a lot with the electronic speed controller during the flight. For instance, your command to increase the speed will travel from your remote control to the ESC, which, in turn, will send the signal to the motors, ordering them to reduce power. To guarantee this collaboration, you have to connect the ESC to the motors. For that, there are three cables linked to the motor that you have to plug in the ESC. Make sure that each cable corresponds to its position.

Step 5. Attach the motor to the arm

Now, you have to mount the motors onto the arms. This is not a difficult task, as the motor uses traditional screws to attach. Just be sure you use all four screws with each engine. Also, please ensure that the motor cables, used to connect to the ESC, are oriented to the inside, not to the outside. If you mistake the direction, it’s not a big deal. It’s just the fact that you will have to spend extra time on unscrewing the motor and placing it the right way.

Step 6. Install the top board

The top board is designed to host the autopilot. There is no big science in mounting it. Just secure it with screws onto the top of the aircraft’s arms.

Step 7. Attach the receiver

Another important step in the Dji f450 fpv setup is to attach the receiver, which plays an important role in the operation of the device as it receives and sends radio signals, ensuring the communication between the flying drone and the pilot found on the ground. You have to attach the receiver to the bottom board, rather than on the top board. This is made to ensure that there are no obstacles in reaching to the pilot and remote control.

F450 uses a Frsky reciever which is a reputed brand offering the highest quality radio transmission. You can navigate their collection of receivers and other rc accessories here.

Step 8. Add the telemetry module

The telemetery module provides valuable flight information from the drone to the transmitter, so that the pilot can see it and make the proper adjustments to improve the flight. The module needs to be attached onto the bottom board using double-sided tape.

On the whole, if you are savvy about electronics, you can assembly Dji f450 in about 90 minutes. The process is a bit complicated, but even an amateur can do it, by following the guideline from the instruction manual. In the end, you will get an amazing copter for entertaining and training that conquers the sky and performs breath-taking stunts.

Trả lời

Email của bạn sẽ không được hiển thị công khai. Các trường bắt buộc được đánh dấu *